| Home > How To Revolt!
All Informational Articles Intended For 18+ONLY:
How To Use and Fill A Cartomizer:
1To begin, First, unwrap your Cartomizer and remove the rubber ends
2Second, you will need to remove the circular plug (they are usually white or clear) and you will notice a tiny hole in the center of this, yes it does pop out! Once done, you will be able to see polyfill material when you look down into your cartomizer now.
3Third, remove the cap to your E-Liquid
4Fourth, Proceed to add 20-25 drops of E-Liquid down into the Cartomizer-keep count as you do this to avoid overfilling.
5Fifth, allow the cartomizer to set for a minute or two, this will allow the filling inside to saturate the liquid and prime it for vaping and will help you to avoid burning out your tip, it must be wet enough so let it saturate for the full amount of time.
6Next: reinsert the plug with the hole or you may insert a 'drip tip' if you have once available-these take the places of plugs.
7Next, rotate the cartomizer onto the threading of your electronic smoking device or vaporizer.
8Finally, you have filled your Cartomizer and are ready to vape! Hold down the button or switch on your mod for a moment, and proceed to vape as desired.
9A Final Note: When your tips need more E-Liquid after the initial fill, each cartomizer can be refilled with an estimated 10-15 drops as needed. A Cartomizer can last about 1-2 weeks estimated. Enjoy your mod-this information was intended for 18+ only!
How To Use An Atomizer:
1Unwrap your atomizer-you can attach a drip tip now if you would like, this is optional but recommended.
2Attach it to the threading found near the top of your device of choice (making sure the threading is compatible with your atomizer in advance).
3The first method is to get the tip filled without the use of a cartridge, simply add 2-3 drops at a time, allow liquid to set for a minute on first use (more than 2-3 drops will flood atomizers)
4The other option is to use atomizer catridges that fit down into your atomizer and they will hold about 10-15 drops at a time (also these are replaceable)
5The atomizer has the same life span either way, it is just more time consuming to go without the cartridges because you will need to add E-Liquid more often to the atomizer.
6Atomizers are estimated to have a vape-span of about 1 to 2 1/2 weeks, which is believed to be a bit longer than the comparable cartomizers. This varies.
How To Fill and Use A Dual Coil Tank:
1First, remove the drip tip or the top handle-piece.
2Second, push the inner tube also known as the 'replacement dual coil cartomizer' down about 1/3rd of the way until you see the lower section hanging underneath the tank body, stop when it's this far down.
3Third, proceed to fill the tank 7/8's full of E-Liquid.
4Fourth, drip E-Liquid down into the body of the cartomizer after that to wet it.
5Slide Cartomizer back up into the tank until it's fully inside again.
6Next, secure top-handle-piece back onto top after wetting o-ring of this prior--- you will hear a snap and then know that it's secured again.
7Finally, turn it onto the threading of the electronic cigarette that it accompanies and proceed to vape. Refill as needed.
How To Use a Drip or Dripper Tip:
1Take the drip tip out if its wrapper.
2Remove the plug from your tip or cartomizer.
3Now, the drip tip can be pushed inside the opening of the tip where the plug once was- you will probably hear a soft snap when it is secure.
4Now drip E-Liquid or E-Juice down into the cartomizer to soak the contents, be careful not to overdo it.
5You may leave the Drip Tip or Dripper Tip in place after you fill the cartomizer, if serves as a funnel for E-Liquid and removes the need for a plug, double purpose!
You can also find more about vaping and general information on some of the following forums (we are vendors on each of them):
(Vapersforum) *must be registered to view.
(ECF) *must be registered to view.
(Creative Liquids) *must be registered to view.
(EcigAdvanced) *must be registered to view.